Optec Venum Hybrid LSO Back Brace

Optec Venum Hybrid LSO Back Brace Features

• Mechanically advanced single or dual compression closure system provides a 6:1 pull ratio
• Posterior panel is available in independent or central support panel designs which creates a natural support system for the spine that can be customized to provide the perfect fit
• Ergonomic arthritic grips can be customized to patient size by extending or retracting cable length
• Made of durable,highly breathable, soft, hypoallergenic materials that wick away perspiration
• Fits waist circumferences from 21" – 63"; optional extender panel adds 10" to circumference

When to use Venum Hybrid LSO?

• Chronic Back Pain
• Degenerative, Herniated or Bulging Disc
• Spondylolysis
• Spondylolisthesis
• Spinal Stenosis
• Facet Syndrome
• Tumors
• Spinal Instability
• Burst FX
• Pre or Post-Op Spinal Lumbar Stabilization
• Pre or Post-Op Disk Surgery

Optec Venum Hybrid LSO Back Brace User Manual
 

How to fit the Optec Venum Hybrid LSO Back Brace?

Sizing Belt

1. Detach pull handles off soft panel surface starting point.
2. Open clamp on each side and detach panels by pulling up and away from hook surface.
3. Set adjustment indicator window over desired size, fold neatly and press down firmly.
4. Place belt panels back in clamp and press down firmly.






 
5.  
6.  
7.  
8.  

Fitting Brace

1. Place handles back on soft panel surface starting point.
2. Pull ends in opposite directions to reset locking mechanism.
3. Position brace around your back, with back plastic panel(s) centered on your spine and the curve on back panel directly over your spinal curvature.
4. Place left soft belt panel against your abdomen.
5. Place right soft belt panel with hook interface over left panel snug and press down firmly.
6. Remove reel from pull handle pocket, and decrease or increase length by reeling cable in or out, respectively.
7. Pull ergonomic handles, outward to achieve desired compression and fasten onto front soft panel (With desired compression, pull handles end up near midline, otherwise repeat step 10).

Maintenance And Care

• Brace may be worn over a cotton shirt.
• Fold the brace and attach the handles near the power units when not in use.
• Before cleaning your brace remove all plastic inserts and panels. Hand wash the fabric with mild soap and cool water. Rinse well and allow the brace to air dry completely in a shaded area. Do not expose the brace to a direct heat source (heater or direct sunlight). Never iron, dry clean or use any substances containing chlorine. Your practitioner knows your medical status and is using the brace as part of your total care. It is important to follow your practitioner’s instructions even if they differ from some of the preceding guidelines.