Pride Jazzy EVO 613 Power Chair

Features of Pride Jazzy EVO 613 Power Chair

• Narrow base width of only 22"
• Maximum speed up to 5.1 mph
• 3" Ground clearance
• 13" solid drive tires
• Per charge range up to 17 miles with U1 SLA batteries and up to 21 miles with lithium-ion (200 lbs.)
• Mid-wheel 6 Technology offers a tight turning radius around doorways and corners
• Pride FDA Class II Medical Devices are designed to aid individuals with mobility impairments
• Pride's patented Active-Trac (ATX) Suspension ensures a smooth ride experience over uneven surfaces
• Memory foam high-back seat with single seat post allows the user to swivel
• Height, width, and adjustable angle armrests
• Flip-up, height, angle, and depth adjustable foot platform
• Removable matte-finish color-through shrouds

Pride Jazzy EVO 613 Power Chair Parts

1. Seatback
2. Armrest
3. Seat Base
4. Controller
5. Top Shroud
6. Main Circuit Breaker
7. Front Caster Wheel
8. Front rigging (foot platform shown)
9. Drive Wheel
10. Seat Release Lever (optional)
11. Rear Caster wheel
12. (A) Seat assembly
13. (B) Power base assembly

 

What to buy with Jazzy Evo 613 Powerchair

• Guldmann Wide Plain Ramp
• Sammons Preston StandEasy Chair Lift
• Graham-Field Single Release Folding Walkers - Standard Rubberized PVC Grip

How to use Jazzy Evo 613 Series Power Chair?

To install the seat:

1. Slide the seat down onto the power base.
2. Install the controller into one of the armrests. Tighten the set screw with the supplied hex key.
3. Lift the armrest straight up, route the controller harness and secure it with wire ties.
4. Plug the controller harness into the connector on the power base.

To change the seat height:

1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
3. Disconnect the controller connector from the power base.
4. Disengage the seat release lever.
5. While holding the lever, swivel the seat left or right and pull it up and off the power base.
6. Loosen the hardware at the rear of the seat post. See figure 8.
7. Remove the seat height adjustment bolt, washers, and nut from the seat post.
8. Raise or lower the seat post to the desired position.
9. Reinstall the seat height adjustment hardware to the seat post.
10. Tighten the hardware at the rear of the seat post.
11. Reinstall the seat.
12. Reconnect the controller to the power base.

To charge the batteries using the off-board charger:

1. Position the front of your power chair next to a standard electrical outlet.
2. Be certain the controller power is turned off, and the freewheel levers are engaged. See III. “Your Power Chair.”
3. Plug the off-board charger into the off-board charger/programming socket on the controller.
4. Plug the off-board charger into the electrical outlet.
5. When the batteries are fully charged, unplug the off-board charger from the electrical outlet and then from the controller

Pride Jazzy EVO 613 Power Wheelchair User Guide

• Pride Jazzy EVO 613 Power Chair User Manual
• Jazzy EVO 613 Series Powerchair Specification Sheet