Optec Oasis PRO LSO LumboSacral Back Support Orthosis

Optec Oasis PRO LSO Features

• Indicated for:
  - Burst FX
  - Post-op spinal lumbar stabilization
  - Post-op disk surgery
  - Chronic back pain
  - Compression Fx
  - Degenerative, herniated or bulging disc
  - Spondylolysis
  - Spondylolisthesis
  - Spinal stenosis
  - Facet syndrome
  - Tumors or inflammation
  - Spinal instability
  - Post-op laminectomy
• Standard components:
  - Corset back and front
  - Anterior polymer panel
  - Posterior polymer panel

More On Optec Oasis PRO LSO

Patient fitting instructions:

• Place the orthosis around your waist with the side closure pre-attached to the left side of the front panel. Proceed to attach the right hook and loop attachment to the right side of the front panel.
• Align the orthosis so that front panel is centered over your abdomen and the center of the back panel is aligned over your spine.
• Using the arthritic thumb grips, detach the bottom compression straps and pull straps simultaneously away from your body.
• Secure the left strap to the center of the orthosis followed by the right strap. Repeat for top strap if applicable.
• Finally, ensure that the orthosis fit is snug and does not cause any discomfort.
• For best results, re-tighten the straps while lying on a bed with your knees bent and feet flat.
   

Care Instructions:

• Always wear a t-shirt or orthopedic body sock under your orthosis.
• To clean the orthosis, hand wash it with mild soap in cool water.
• Allow the orthosis to air dry.
• It is not uncommon for your body to change size while wearing the orthosis because of the compression and reduction in post-surgical swelling.
• If you change enough in size that you can no longer adjust the straps to achieve compression, see your practitioner for a follow-up visit to resize or replace your brace.