Kanga Adult Tilt-In-Space Wheelchair

Features of Kanga Adult Tilt in Space Wheelchair

• Tilts-in-space up to 45 degrees
• Adjustable frame width and depth
• Kanga Tilt-In-Space Wheelchair has a folding frame that is easy to transport and store
• Armrests are height-adjustable and removable
• Adjustable height and angle backrest
• Multiple positioning accessories are available
• Transit brackets included for securing an unoccupied wheelchair in a vehicle
• Width adjustable solid seat pan included
• 20” rear wheels included
• Removable anti tippers included

Kanga Adult Tilt-In-Space Wheelchair User Manual
 

What to buy with Kanga Adult Wheelchair

• Graham-Field Lumex Convoluted Foam Cushion
• Armrest Pad Covers
• Multi-Mount Drink Holder

Also Available:

• Kanga Adult Tilt-In-Space Wheelchair Backrest
• Kanga Adult Tilt-In-Space Wheelchair Footrest
• Kanga Adult Tilt-In-Space Wheelchair Headrest
• Kanga Adult Tilt-In-Space Wheelchair Legrests
• Kanga Adult Tilt-In-Space Wheelchair Rear Wheel Assembly

How to assemble Drive Kanga Tilt-In-Space Wheelchair?

1. Open frame by pulling right and left side frames apart and pushing down on the cross brace until fully extended.
2. Install right and left rear wheels by pushing the quick release axle button (located in the center of the wheel) and sliding it into the axle sleeve until it locks. To remove, push the quick release button and pull out from axle sleeve.
3. Raise right and left back canes until both back canes click into place.
4. To install solid seat pan, first remove threaded knobs from front seat pan brackets.
5. Snap solid seat pan onto seat rails of wheelchair.
6. Insert threaded knobs into front seat pan brackets and tighten.

How to fold Drive Kanga Adult Wheelchair?

• Remove armrests by pushing silver button on armrest receiver and pulling armrest out of receiver.
• Push orange button on rigidizer bar to allow bar to fold with wheelchair frame.
• Lift up footplate or remove footrest.
• Push backrest folding levers toward back canes and fold back canes forward.
• Lift strap on top of cross bar to fold wheelchair frame and press the side frames together.

How to care for Kanga Adult Tilt-In-Space Wheelchair by Drive?

• Wipe aluminum parts with a clean, soft cloth at least once a week.
• All metal parts can be cleaned with mild detergent on a soft cloth. If exposed to moisture, dry immediately. Do not use abrasive cleanser that will scratch the finish.
• Tires should be cleaned occasionally with a damp cloth.
• Replace tires if they become severely worn or cracking appears.
• Front Wheels should be checked periodically and lubricated occasionally.
• Lubricate by removing fork and greasing caster stem bearings.
• Lubricate wheel bearings by removing wheel from fork. Reassemble fork and wheel by tightening nuts until no play remains, but wheels roll freely.
• If nut is too loose, wheel will shimmy, if too tight, chair will be hard to steer.
• Rear Wheels should be inspected at least once a month and make sure each spins freely.
• To adjust the play, remove the wheel and with a wrench on the axle nut and on the flat end on the other side adjust the length of the axle until the wheel has the least amount of side play when the plunger pops out.