Hollister Pouchkins One-Piece Flat Standard Wear Cut-To-Fit Transparent Urostomy Pouch

Features

• Hollister Pouchkins One-Piece Flat Standard Wear Cut-To-Fit Transparent Urostomy Pouch with tap has attached cap
• Flat, SoftFlex (standard wear) skin barrier without starter hole
• Transparent odor-barrier pouch film
• No tape border
• Comes with adapter and soft beige ComfortWear pouch panel on the body side only
• Not made with natural rubber latex
• Length: 8-3/4" (22cm)

More Information

• Using Instructions:
  Collect Supplies
  Gather pouch, scissors, pen, water, and gauze, cotton balls, or tissue.
  Prepare the Pouching System:
  - Measure the stoma using a sizing guide or use a pattern provided by your nurse.
  - Trace the pattern onto the skin barrier. The skin barrier should fit closely around the stoma.
  - Pull the pouch film away from the skin barrier. Using small curved scissors, carefully cut an opening in the skin barrier to match the pattern. Do not cut beyond the line on the release liner. Do not puncture the pouch.
  - Remove the release liner from the skin barrier. Set aside with adhesive facing up.
  Remove Used Pouching System
  - Carefully lift an edge of the skin barrier and peel downward, gently pushing the skin away from the skin barrier. Properly dispose of used pouch. Do not flush down the toilet.
  - Clean the skin with water or with gentle soap as recommended by your healthcare provider. Rinse and dry thoroughly. Do not use oils, powder, lotion, or lotion-type soaps on the skin.
  Apply the New Pouching System:
  - Center the skin barrier opening over the stoma.
  - Gently press the barrier against the skin until the entire barrier adheres.Close bottom of the pouch.
  - Close spout at bottom of pouch.
  - Fold up three times until the plastic fasteners meet. Press firmly from the center to the outer edges along the closure strip.
  - The skin around the stoma should not be irritated or broken. If the skin is irritated, contact a WOC Nurse or ostomy specialist.