Drive Pull Cord Alarm

Features

• Drive Pull Cord Alarm sounds when pin is pulled from unit
• Activation cord is adjustable from 18" to 36"
• 2 volume settings: 97 dB and 103 dB
• Requires one 9V battery (included) or AC adaptable (adapter sold separately).
• Deactivate with On/Off switch

More Information

• How to use:
  - Turn unit on using switch located on side of alarm unit
  - Test unit by pulling pin to activate alarm
  - Set switch to Low or Hi position, depending upon necessary alarm volume
  - Secure alarm to bed or chair using plastic clip on back of alarm or included hook and fastener
  - When using clip on wheel chair back, position to left or right to avoid contact with resident
  - Clip end of cloth cord to a piece of clothing the resident is not likely to remove
  - Clip should be out of residents reach if possible
  - If resident leaves chair or bed, activation pin pulls from alarm and alarm sounds continuously
  - To deactivate alarm, turn switch to OFF or reinsert activation pin located at end cloth cord
  - Once resident has returned to chair or bed, turn alarm on and retest
• Set up:
  - Insert one 9-volt battery into battery compartment of alarm
  - To open battery compartment, depress both clips separate top and bottom pieces
  - If using adhesive backed hook to secure alarm, apply hook to backside of alarm box

 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov