Drive Pediatric Fingertip Pulse Oximeter

Features

• Drive Pediatric Fingertip Pulse Oximeter features child-friendly design
• 4-way OLED with six display modes
• Adjustable brightness levels from 1 to 10
• Prescription required
• Portable, non-invasive spot check of oxygen saturation and pulse rate
• Uses 2 AAA batteries
• Comes in retail box
• Lanyard, silicon case, and hang bag included
• Low battery indicator
• Note: Prescription required
• Click Here For Manual

More Information

• Precautions For Use:
  - Before use, carefully read the manual
  - Operation of the fingertip pulse oximeter may be affected by the use of an electrosurgical unit (ESU)
  - The fingertip pulse oximeter must be able to measure the pulse properly to obtain an accurate SpO2 measurement. Verify that nothing is hindering the pulse measurement before relying on the SpO2 measurement
  - Do not use the fingertip pulse oximeter in an MRI or CT environment
  - Do not use the fingertip pulse oximeter in situations where alarms are required. The device has no alarms. It is not for continuous monitoring
  - Do not use the fingertip pulse oximeter in an explosive atmosphere
  - The fingertip pulse oximeter is intended only as an adjunct in patient assessment. It must be used in conjunction with other methods of assessing clinical signs and symptoms
  - In order to ensure correct sensor alignment and skin integrity, the maximum application time at a single site for our device should be less than half an hour
  - Do not sterilize the device using autoclaving, ethylene oxide sterilizing, or immersing the device in liquid. The device is not intended for sterilization
  - Follow local ordinances and recycling instructions regarding disposal or recycling of the device and device components, including batteries
  - This equipment complies with IEC 60601-1-2:2007 for electromagnetic compatibility for medical electrical equipment and/or systems. However, because of the proliferation of radio-frequency transmitting equipment and other sources of electrical noise in healthcare and other environments, it is possible that high levels of such interference due to close proximity or strength of a source might disrupt the performance of this device
  - Portable and mobile RF communications equipment can affect medical electrical equipment
  - This equipment is not intended for use during patient transport outside the healthcare facility
  - This equipment should not be used adjacent to or stacked with other equipment
  - Do not disassemble, repair or modify the equipment without authority
  - These materials that contact with the patients skin contain medical silicone and ABS plastic enclosure are all pass the ISO10993-5 Tests for invitro cytotoxicity and ISO10993-10 Tests for irritation and delayed-type hypersensitivity
• Rx only:
  Caution: Federal law (USA) restricts this device to sale by or on the order of a licensed practitioner.
• It may be unsafe to:
  - Use accessories, detachable parts and materials not described in the instructions for use
  - Interconnect this equipment with other equipment not described in the instructions for use
  - Disassemble, repair or modify the equipment
• Contraindication:
  - It is not for continuous monitoring
• Maintenance and Storage:
  - Replace the batteries in a timely manner when low voltage lamp is lighted
  - Clean surface of the fingertip oximeter before it is used in diagnosis for patients
  - Remove the batteries if the oximeter is not operated for a long time
  - It is best to store the product in -20+55 and 93% humidity
  - Keep in a dry place. Extreme moisture may affect oximeter lifetime and may cause damage
  - Dispose of battery properly; follow any applicable local battery disposal laws
• Cleaning the fingertip pulse oximeter:
  - Please use medical alcohol to clean the silicone touching the finger inside of Oximeter with a soft cloth dampened with 70% isopropyl alcohol.
  - Also clean the being tested finger using alcohol before and after each test
  - Do not pour or spray liquids onto the oximeter, and do not allow any liquid to enter any openings in the device
  - Allow the oximeter to dry thoroughly before reuse.