Drive Knock Down Deluxe Steel Drop Arm Tool Free Commode

Features

• Drive Knock Down Deluxe Steel Drop Arm Commode has easy to assemble frame
• Padded open front vinyl toilet seat
• Legs are height adjustable
• Comes with 12qt commode bucket with carry handle and splash shield
• Also available (Sold separately)
  - Nova Medical Toilet Support Rails
• Note: This item cannot be returned or exchanged due to hygienic reasons

More Information

• Commode assembly:
  - Remove contents from box. Depress brass push pins and insert bucket frame section into first arm. The push pins will snap into place when frame in securely in place
  Note: Make sure the back of the bucket frame (the side with the back rest receptacles) corresponds to the back of the armrest section
  - Repeat for second arm section
  - Insert backrest into backrest receptacles in commode bucket frame. The brass push pins will snap into place when secure
  - Align the toilet seat clamps onto the back frame rail. (Both clamps should sit outside the pail brackets). Push down on seat until clamps snap firmly into place. To remove, grasp the back of the seat and lift
  - Install commode bucket by dropping into bucket frame. Reverse to remove
• Adjusting leg height:
  - Before use, adjust height of each leg to your specific needs, making sure all legs are at the same height. When desired height is reached, lock legs into place by aligning buttons into proper holes
  - To be sure legs are locked into place by pushing down on or by pulling legs
• Precautions:
  - Toilet seat must be in down position before use. Failure to do so may result in breakage of commode and possible injury
  - Do NOT install commode without first reading and understanding this assembly and instruction sheet. If you can not understand these instructions, contact a healthcare, dealer or technical professional before attempting to install. Otherwise, injury or damage may occur
  - Inspect all parts for shipping damage before assembly. If there is shipping damage - Do Not Use. Contact dealer/carrier for further instructions
  - Make certain that the height adjusting snap buttons fully protrude through the same respective hole of each leg extension. This will ensure that the leg extensions are securely locked in position and an even height is achieved
  - Ensure ALL screws, nuts and/or bolts are tightened
  - Check the rubber tips on the leg extensions for rips, wear or if they are are missing. Immediately replace any or all if any of these imperfections exist
  - All four leg extensions with rubber tips MUST touch the floor simultaneously at all times
  - Users with limited physical strength should be supervised or assisted while using commode
  - To operate the drop arm, push the lever forward to release and drop the arm. To return the arm rest to the upright position, pull the arm up until the lever latch clicks into place. Caution, do not lean or push down on the arm rest until the latch has been checked to insure the latch is in place and will hold weight

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov