Medquip Airial Panda Pediatric Nebulizer Features
- Black and white panda design is a child-friendly design for your child's comfort
- Durable, piston-driven system
- The tube attachment system is located at the back of the compressor
- Offers 4 to 8L/min liter flow range
- Weight of the nebulizer compressor: 4.3 lbs
What to buy with Drive Medquip Nebulizer
Guidelines for Drive Medquip Airial Panda Pediatric Compressor Nebulizer
How to operate Drive Panda Nebulizer?
Important: Prior to initial operation, this product should be thoroughly cleaned per the Cleaning Procedures in this guidebook
- Place your compressor Nebulizer on an at and stable surface. Be sure that you can easily reach the controls when you are seated
- Fill the bottom section of the nebulizer cup with the medication prescribed by your Physician. Be sure that the cone is put inside the bottom section. Place the cone inside and ll medication
- Gently twist the top part clockwise to reassemble the nebulizer cup. Be sure the two sections t well
- Attach one end of the air tube to the base of the nebulizer cup
- Attach the other end of the air tube to the air-tube connector located on the back of the compressor
- Attach the interface accessory of your choice to the top section of the nebulizer cup
- Plug the power cord into an appropriate electrical outlet. Make sure, at this stage, the power switch is at OFF status
- Press the power switch to ON status to begin your prescribed treatment
Important: The compressor motor has a thermal protector, which will shut off the unit before the unit is overheated. When the thermal protector shuts the unit off, please
- Switch off the unit
- Unplug the unit from the electrical outlet
- Wait 30 minutes for the motor to cool down before another treatment
- Make sure the air openings are not obstructed
- When treatment is finished, shut off the unit and unplug it from the electrical outlet
How to clean Medquip Panda Pediatric Compressor Nebulizer?
- It is recommended that the nebulizer and the mask (or any other patient accessory interface that is used) be thoroughly cleaned with hot water after each use and cleaned with a mild detergent after the last treatment of the day
- If your physician or respiratory therapist species a different cleaning procedure, follow their instructions
Rinse Panda Compressor Nebulizer (after each treatment)
- Disconnect the air tube from the nebulizer cup. Disconnect the mask or other patient accessory interface from the nebulizer cup
- Gently twist the top part of the nebulizer cup counter-clockwise to disassemble the nebulizer
- Rinse the nebulizer cup and mask (or another patient interface) with water
- Let these components air dry away from direct sunlight
- Reassemble the nebulizer cup when completely dry and put these parts in a dry, sealed container
Disinfecting Medquip Airial Panda Nebulizer
- Use one part white vinegar with three parts distilled water. Make sure the mixed solution is enough to submerge the nebulizer, mouthpiece, and mask
- Complete Rinsing Steps 1-3
- Wash the nebulizer, mouthpiece, and mask in warm water and a mild detergent. Then wash them in hot tap water
- Submerge these parts in the vinegar and water solution for thirty minutes
- Complete Rinsing Steps 3-5
Cautions:
- Keep the unit away from water
- Do not immerse the power cord or the unit in liquid
- Do not use it while bathing
- Do not reach for a unit that has fallen into water - immediately unplug the unit
- Never operate the unit if it has any damaged parts (including the power cord) or if it has been dropped or submerged in water. Promptly send it to a service center for examination and repair
- The unit should not be used where products are being used
- Disconnect the unit from the electrical outlet before cleaning after each use
- Do not use other attachments unless recommended by the manufacturer
- This appliance has a polarized plug (one blade is wider than the other)
- Operating Cautions:
- Connect this product to an appropriate voltage outlet for your model
- Do not run this product unattended
- Never operate the unit if it has any damaged parts (including the power cord) or if it has been dropped or submerged in water. Promptly send it to a service center for examination and repair
- If any abnormality occurs, discontinue use immediately until the unit has been examined and repaired
- Always unplug the product immediately after use
- Never block the air openings of the main unit or place it where the air openings may be obstructed
- Storage Cautions:
- Do not store the unit in direct sunlight, high temperatures, or high humidity
- Keep the unit out of reach of small children
- Always keep the unit unplugged while not in use
- Cleaning Cautions:
- Do not immerse the unit in water. It may damage the unit
- Disconnect the unit from the electrical outlet before cleaning
- Clean all necessary parts after each use as instructed in this guidebook
Medquip Airial Pediatric Nebulizer Specifications
Particulars |
Specifications |
Power |
AC 120V, 60Hz |
Current |
1.5 A / 0.8 A |
Medication Capacity |
5ml |
Particle Size |
0.5 to 10µm |
MMAD |
4 µm |
Sound Level |
Around 60 dBA |
Maximum Medication capacity |
13ml (cc) |
Average Nebulization Rate |
0.2ml/min |
Compress or Pressure Range |
25 to 42 Psi |
Operating Pressure Range |
8 to 13 Psi |
Liter Flow Range |
5 ~ 8 lpm |
Operating Temperature Range |
10°C to 40°C (50°F to 104°F) |
Operating Humidity Range |
10 to 95% RH |
Storage Temperature Range |
-20°C to 70°C (-4°F to 158°F) |
Storage Humidity Range |
10 to 95 % R H |
Dimension (L x W x H) |
188. 0 — 169. 5 — 136.5mm |
Noise level |
55 dBA |
Â
Panda Nebulizer Warranty
5 year limited warranty
Related Articles
{{x.ShortDescription}} ...
Share
Medquip Panda Nebulizer Reviews