Chattanooga Intelect Legend XT Channel 3 and 4 Electrotherapy Module

Features

• Chattanooga Intelect Legend XT Channel 3 and 4 Electrotherapy Module is ideal for the growing clinic or the clinician on a budget
• Color-coded front access panel that hides excessive connections and lead wires
• Upgrade therapy unit to 4 independent channels available from 2 channels
• Can be used as an accessory with the following models:
  - Chattanooga Intelect Legend XT 4 Channel Electrotherapy System (Code: 2786)

More Information

• Installation Procedure:
  - Disconnect the Mains Power Cord from the power supply. Remove the Rear Access Panel and disconnect the Mains Power Cord from the Therapy System
  - Remove the Front Access Cover and disconnect the Lead Wires and Accessories
  - Remove the Therapy System from the Therapy System Cart, if equipped. Place Therapy System face down on a clean working surface protected with a soft, clean fabric to prevent damage to the lens
  - Do not remove the sEMG Module, if installed
  - Remove and discard the vinyl label holding the Ribbon Cable in the cavity
  - Carefully unroll the Ribbon Cable, making certain not to disconnect it from the Therapy System
  - Carefully align the Ribbon Cable Connector to the Module Connector Pins and press down to connect
  - Set the Therapy System on the Module
  - Make certain the Feet of the Therapy System are resting in the Module Indents
  - Carefully place the Therapy System and Module on one side
  - Tighten screws until the Module does not move on the Therapy System
  - Remove the screw retaining the existing Front Access Panel
  - Install Lanyard to the new Extended Front Access Panel using the same screw
  - Install Lead Wires and additional accessories to Front Panel
  - Install the new Extended Front Access Panel onto Therapy System
  - Make certain Lanyard does not become kinked
  - Connect the Mains Power Cord to the Therapy System
  - Install Rear Access Panel. Connect the Mains Power Cord to an approved power source
  - Turn the System On using the On/Off Switch
  - The System will automatically recognize the added Module and display a configuration change message
  - Read and carefully follow the instructions on the screen
• Maintenance:
  - Clean the system with a clean, lint free cloth moistened with water and mild antibacterial soap. Do not submerse the system in liquids
  - Clean the Therapy System Screen Lens using NOVUS Polish System