Breg Vectra Premium Air Walker Boot

Breg Vectra Premium Air Walker Boot Features:

• Unique fold-over, integrated air pump and release valve eliminates any unnecessary tibial pressure points
• Medial and lateral air bladders provide enhanced stabilization
• Dual-Axis rocker bottom encourages a more natural gait
• Breathable Airmesh liner with malleable aluminum uprights and removable heel clip
• Common Examples of Use: 
• - Overall support and swelling management of the lower extremity
  - Soft tissue injuries of the lower leg
  - Moderate to severe ankle sprains
  - Syndesmosis (high ankle) sprain
  - Forefoot/midfoot/hindfoot pain and injuries
  - Stable foot and/or stable ankle fractures
  - Post-ORIF and surgical stabilization after tendon/ligament repairs
  - Metatarsal fracture
  - Other acute or post-operative use (i.e. bunionectomy)
• Instruction Manual

More About Breg Vectra Premium Air Walker Boot

• Initial application by a medical professional only:
  - Apply liner to leg
  • With patient seated, leg(s) bent, and feet off floor, position tongue pad as needed for maximum comfort, close liner snugly
  - Slide walker onto leg over the liner straight up directly under foot
  - Position walker with uprights centered over the malleoli (ankle bones)
  - Fasten straps
  • Start with straps 1 and 2 closest to the toes (Straps may be trimmed to desired length by removing tab at end of straps, trimming and reaffixing tab
  - Remove cardstock quick-pulls from the uprights and discard
  - Attach uprights to the liner
  - Press firmly
  - Fasten straps
  Fasten remaining straps 3 through 5
  - Fold down
  • Inflation bulb and affix in preferred location (bulb position is variable and dependent on calf circumference)
  - Close release valve clockwise (to the right)
  - Inflate air bladders by pressing on inflation bulb to desired pressure for maximum comfort and stabilization
  - To release the air, twist the release valve counterclockwise (to the left)
  - To re-inflate the air bladders, twist the release valve clock-wise and press the inflation bulb to desired pressure
  - Optional
  • To enhance liner fixation, attach the 1"x 1 /2" hook pieces to the liner at malleoli foam pads (or on the foot bed of the walker)
  - Optional
  - Heel clip removal
  - Pull up on the heel clip
  - Optional
  • Heel clip replacement; Lift up foot bed padding and foot plate
  • Slide heel clip into place using the dove-tail slot guides
  • Release and push the foot plate and padding down into proper position 
•  Care Instructions:
  - After initial application, the Vectra walker boot may be removed and reapplied without removing liner from boot
  - Hand wash the liner and straps with mild soap, rinse thoroughly and air dry
  - Do not wash or dry in any mechanical device