Blackhawk Extended Digital Outrigger Hand Splint Kit

What does Blackhawk Outrigger Splint Include?

• (5) 6" (15cm) long extension rods
• (5) Plastic tip protectors
• (5) Adjuster pieces, each with three set screws
• (5) Finger loops with attached monofilament line and line stoppers
• (2) MP outrigger frames: one 5-1/2"(14cm) wide, one 4-3/4" (12cm) wide
• (5) Sticky-back D-ring hookup straps
• (1) Hex wrench
• (10) Synthetic elastic bands

Features of Blackhawk Extension Outrigger Splint

• The preformed outrigger wire frame follows the arch of the hand and can be attached to the thermoplastic splint base (not included)
• Two outrigger frames are included and can be fitted to any size hand
• The adjuster piece mounts onto the outrigger frame to hold the extension rod
• Joint position is adjusted by rotating the adjuster piece and extension rod alignment
• Each extension rod can be shortened or lengthened to accommodate different fingers and joints
• Rod ends act as line guides so each respective finger loop holds the digit in correct alignment
• Thermoplastic and straps sold separately
• Additional replacement parts also are available

Blackhawk Outrigger Hand Splint User Manual

What to buy with Outrigger Hand Splint

• Capzasin-HP Arthritis Pain Relief Creme
• Fabrication Point Relief ColdSpot Roll-On
• Rolyan Gel Padding

When to use Blackhawk Outrigger Hand Splint?

• Post radial nerve injuries
• Post MCP arthroplasty
• Fixed bony contractures
• Unstable fracture conditions