Action Products Xact Classic Cushion

Action Products Xact Classic Cushion Features

• Outstanding pressure distribution and anti-shearing properties
• Help the user maintain a comfortable, therapeutic position
• Offers improved support for gluteal areas and bony protuberances
• Incontinent and replacement covers are also available
• Avoid exposure to direct sunlight

What to buy with Action Foam Xact Classic Cushion

• Action Products Shear Smart Cover
• Skil-Care Cushion Pad Protector
• Skil-Care Low Shear II Cover

Assembly of Xact Classic Cushion

1. Place the cube pad on top of the foam base so that it covers the entire surface area.
2. Make sure that all hook and loop strips on the cube pads are in firm contact with the corresponding hook and loop strips on the foam base.
3. Insert the foam base with the attached cube pad into the cover with the thin side of the base facing the zipper side of the cover (the bottom of the cushion should be the closest zipper).
4. Make sure there are no creases in the cube pad before zipping the cover without catching the foam base or cube pad with the zipper.
5. Always check that the cube pad is evenly draped and fully attached to the foam base after transportation.

Cleaning of Action Xact Cushion

• Carefully remove knit covers before cleaning wheelchair pads. Keep film corners and edges away from the zipper
• Recommended use of a 1:10 solution of bleach and water to clean the cube pad.
• May also use any conventional hospital-approved topical equipment cleaners and disinfectants that do not contain alcohol. Thoroughly clean pad with solution
• ALWAYS THOROUGHLY rinse pads with clear water before placing the user on pad or refitting cover to pad. This helps eliminate the possibility of skin irritation due to cleaning solution residue
• DO NOT use alcohol to clean pads. It may cause hardening or discoloration of the surface.
• Autoclaving and Gas Sterilization NOT recommended
• Foam base should be cleaned with a moist cloth. Never immerse base in water
• Anti-bacterial soap or 1:20 solution of bleach may be used (Bleach is a 5-10% solution of Sodium Hypochlorite)