McKesson Fiberglass Cast Tape - Pink

McKesson FiberglassCast Tape Features

• McKesson Casting Tape dries quickly 
• Handle pressure on it within twenty minutes
• Water-activated resin lets you control working time according to application needs
• High and early strength allows for weight bearing in 20-minutes and provides a durable cast with less chance of breakdown and the need for costly repairs or replacements
• Lightweight for easy mobility
• Stretches to conform well to contours for a more comfortable better-fitting cast
• Porous weave allows the skin to breathe

What to buy with McKesson Cast Tape

• McKesson Baby Wipes with Aloe and Vitamin E
• McKesson Fiberglass Cast Tape - Blue

How to use McKesson Cast Tape Pink?

1. Preparation of the site, wound management, fracture reduction, postsurgical care and general patient supervision should follow established practices. 1. Slip one or two layers of stockinet over the affected part, and/or wrap with McKesson cast padding. If desired, additional cast padding may be used for greater protection of pressure points and bony prominences. It is important to use a water-shedding stockinet and cast padding to enable thorough drying if the cast should be immersed in water.
2. Gloves MUST be worn while wrapping the casting tape since the resin in the tape will transfer and adhere to the skin.
3. Select the desired width of McKesson casting tape. Open only one roll at a time, since room humidity may initiate hardening.
4. Immerse the roll of tape in room temperature water 70-75°F (21-24°C). NOTE: Three firm squeezes of the roll while it is submerged will give a set time of approximately 3 minutes. To lengthen the set time, immerse the roll and remove it immediately without squeezing. This technique will give a set time of approximately 4 minutes. When using McKesson casting tapes, there may be a decrease in slipperiness if the roll is not squeezed while submerged in water. Warmer water shortens the set time while cooler water will lengthen it. If the roll is immersed in water above 80°F (27°C) an increase in exotherm may be noted.
5. Construct the cast by wrapping spirally, overlapping the previous turn one-half to two-thirds the width of the tape. As with any cast, take care to avoid excessive tightness. To ensure a snug fit, however, wrap with slight tension on the tape rather than the rolling application common to plaster. 
6. Just three or four layers provide a strong non-weight-bearing cast and five to eight layers are typically adequate for a weight-bearing cast. Additional layers are generally not necessary for strength and will reduce porosity. If a reinforcing strip is used in conjunction with McKesson casting tapes, immerse the strip in room temperature water, using the same procedure described in No. 4. Apply as you would a plaster splint. Reinforcing strips allow for added strength when desired. 
7. Smooth and rub the tape to achieve good contact between layers. Soon after smoothing, the cast can be molded. The last part of the roll may need a few seconds extra molding with wet gloves, which will improve lamination of the roll-end lay-down.
8. About 3-4 minutes after immersion in water, McKesson tapes are sufficiently rigid to prevent further molding.
9. Allow about 20 minutes before applying loads to weight-bearing casts.
10. Walking heels, cast shoes and bracing devices can all be used with McKesson casts. 
11. Should modification be necessary for therapeutic reasons, additional layers of tape can be applied to an already hardened McKesson cast. The fresh tape should be overlapped on itself to best secure it to the hardened cast